Appendix B Installing In-Sight™ 4000 Series Vision Sensors
44
Force Static IP
Force Static IP mode disables the Use DHCP Server checkbox. If a static IP address
and Subnet Mask were previously assigned to the In-Sight system, those settings will
be used, otherwise, the factory default static IP Address (192.168.0.1) and Subnet
Mask (255.255.255.0) will be used. If the Use DHCP Server checkbox is already
disabled, no changes to the IP address will occur. Like force DHCP mode, force static
IP mode changes the sensor’s Serial Port 1 Mode setting to ‘Native’ to allow Network
settings to be configured from an RS232 device.
To Force Static IP mode, insert the end of a paper clip into the sensor’s reset switch.
Depress the switch for at least five seconds, then remove the paper clip. When all three
LEDs have stopped blinking, the sensor has been restarted. These settings will remain
in effect even after the sensor is powered down.
