Getting Started
1-7
1
4. When the batteries are fully charged, the light turns off.
To charge your batteries again, unplug the AC power
cord, then plug it back in.
Note:
Replace the batteries with new Ni-MH batteries if the
charger light stays on for more than 240 minutes or if
the charger light flashes for more than half an hour.
5. After the light goes off, unplug the charger. To avoid
overcharging, unplug the charger as soon as possible
after the light goes off.
6. Allow the batteries cool, then remove them from the
charger.
w
Warning:
Batteries are very hot (approximately 65°C)
during and just after charging. Let the batteries
cool for one hour before handling.
7. Before storing the charger, disconnect the AC power
cord from the charger and remove the batteries.
Installing the batteries
Before installing the batteries, be sure to read the safety
instructions outlined in “When using the charger and
batteries” on page 5.
Make sure that the camera is off, and follow the steps below
to install or replace the batteries.
1. Turn the camera upside down with the lens facing you.
Hold down the battery cover release button and slide
the battery cover as shown below.
battery cover
release button
