A SERVICE OF

logo

Moving the Secure System Jumper
Step 4: Move
Driveplate
Make sure that the system unit is placed on the table or desk
with enough room at the front of the unit to accommodate the
driveplate as you remove it.
Grasp the rear of the driveplate and gently tilt the entire plate
forward , as shown in Figure 11–3. Disconnect the driveplate
power connector . Release the driveplate from the system unit
and carefully place it aside.
Figure 11–3 Moving the Driveplate
MLO-009207
A .......... TLZ06
B .......... RX26
C .......... TZK10
D .......... TZ30
E .......... RRD42
A
B
C
D
E
1
2
11–8 Using the Password Security Feature