A SERVICE OF

logo

Open as PDF
next previous
Running Diagnostic Tests
If the problem with your system has been fixed, after you
initialize your system, you should be able to issue the
show
config
command and not see any errors. If the problem is
not fixed, contact Digital Services as described later in section
Reporting Problems to Digital Services.
Note: Another
Way to Initialize
Your System
You can also initialize your system after running diagnostic tests
by running the same test again. If the problem has been fixed,
the test, which failed before, will complete successfully.
Figure 14–4 shows a sample display of a successful SCC test.
Figure 14–4 Initializing the System with the SCC Test
>>> test scc
T-STS-SCC-OK
>>>
14–10 Running Diagnostic Tests