10.5 Specifying Default Settings (User’s Choice: 2 Functions)
10
10-23
Utility Mode Operations Chapter 10
Setting the “Auto-select paper for small originals” Function
This function is used to specify whether or not small-sized documents are printed if
the paper size is too small and cannot be automatically detected. (The default
settings are “ON” and the 1st drawer.)
✎
Reminder!
When copying document smaller than 5-1/2
×
8-1/2 L, be sure to position it on
the original glass. If the reverse automatic document feeder is used, a paper
misfeed or damage to the document may occur.
For details on the types of documents that can be used with the reverse
automatic document feeder, refer to “Original Documents” on page 5-1.
If this function is set to “OFF”, the message “Original size cannot be detected.”
appears when the [Start] key is pressed if the “Auto Paper Select” setting was
selected and the size of the document is too small or no document is loaded.
In this case, the paper drawer (desired paper) must be selected in order to make
copies.
If this function is set to “ON”, copies will be made using paper in the specified paper
drawer, even if the document is too small or no document is loaded.
1 Press the [Utility] key.
2 Touch [User’s Choice: 2].
3 Touch [2/3].
4 Touch [Auto-select
paper for small
originals].
