Filter
Top Products
1-8 Quick Start Guide
Getting Started ESG Family Signal Generators
Creating a Step Sweep and a List Sweep
Turning On List Sweep for a Single Sweep
1. Press Return. This moves the softkey menu up one level. Notice that the
Sweep softkey is still set to sweep both frequency and amplitude
data.
2. Press the
Sweep Repeat Single Cont
softkey.
This toggles the Sweep Repeat Single Cont softkey from
Cont to Single. Notice that the SWEEP display annunciator is
turned off.
3. Press the Single Sweep softkey. The signal generator sweeps the points in your list once. Notice
that the SWEEP display annunciator is turned on during the
sweep.
4. Press the More (1 of 2) and
Sweep Trigger softkeys.
A menu is displayed showing you choices for triggering a sweep.
Notice that you had used the default setting, Immediate, when
you triggered the single sweep in the previous step.
5. Press the Trigger Key softkey. This sets Sweep Trigger to Trigger Key and returns you to
the previous softkey menu.
6. Press the More (2 of 2) and
Single Sweep softkeys.
This arms the sweep so that it is ready for triggering. Notice that
the ARMED display annunciator is now turned on.
7. Press Trigger. The signal generator sweeps the points in your list once and the
SWEEP display annunciator appears during the sweep.
qsg.book Page 8 Friday, September 22, 2000 3:13 PM