Filter
Top Products
1-6 Quick Start Guide
Getting Started ESG Family Signal Generators
Creating a Step Sweep and a List Sweep
Turning On Continuous Step Sweep
8. Press the Ampl Stop softkey.
Enter 0 using the numeric
keypad and press the dBm
softkey.
This sets the new power level for the end of the step sweep to
0 dBm.
9. Press the # Points softkey.
Enter 10 by rotating the front
panel knob until the number
10 is displayed.
This sets the number of points in the step sweep.
10. Press the Step Dwell softkey.
Enter 500 using the numeric
keypad and pressing the msec
softkey.
This sets the dwell time for each point in the step sweep.
1. Press Return. This moves the softkey menu up one level.
2. Press the Sweep softkey. Another menu is displayed, showing you choices for sweeping
either the frequency, amplitude, or frequency and amplitude data.
3. Press the Freq & Ampl softkey. Selecting this softkey returns you to the previous menu and turns
the sweep function on.
4. Press the
Sweep Repeat Single Cont
softkey.
This toggles the Sweep Repeat Single Cont softkey from
Single to Cont (Continuous). Notice that the SWEEP display
annunciator is turned on, indicating that the signal generator is
sweeping.
5. Press RF On/Off. Notice that the display annunciator changes from RF OFF to
RF ON. The swept RF signal is now available at the
RF OUTPUT connector.
qsg.book Page 6 Friday, September 22, 2000 3:13 PM