Filter
Top Products
Quick Start Guide 1-3
ESG Family Signal Generators Getting Started
Creating an FM Signal
Creating an FM Signal
This procedure will show you how to configure the signal generator to output a
frequency-modulated signal with the following characteristics:
• carrier frequency set to 104.9 MHz
• power level set to 0 dBm
• FM deviation set to 75 kHz
• FM rate set to 10 kHz
Setting the Carrier Frequency
Setting the Power Level
1. Press Preset. This sets the signal generator to its factory-defined instrument
state.
2. Press Frequency. Frequency becomes the active function and the preset value for
frequency is displayed in the active entry area.
3. Enter 104.9 using the numeric
keypad and press the MHz
softkey.
The new carrier frequency (104.900 000 00 MHz) is
shown in both the FREQUENCY area and the active entry area
of the display.
1. Press Amplitude. Amplitude becomes the active function and the preset value for
amplitude is displayed in the active entry area.
2. Enter 0 using the numeric
keypad and press the dBm
softkey.
The new power level (0.00 dBm) is shown in both the
AMPLITUDE area and the active entry area of the display.
qsg.book Page 3 Friday, September 22, 2000 3:13 PM