Filter
Top Products
Quick Start Guide 1-7
ESG Family Signal Generators Getting Started
Creating a Step Sweep and a List Sweep
Configuring a List Sweep Using Step Sweep Data
1. Press the Sweep Type List Step
softkey.
This toggles the Sweep Type List Step softkey from Step to
List.
2. Press the Configure List Sweep
softkey.
Another menu is displayed with softkeys that you will use to
create the sweep points. Notice that the display shows the
current list data. (When no list has been previously created, the
default is one point set to the signal generator’s maximum
frequency, −135 dBm, with a dwell time of 2 ms.)
3. Press the following softkeys:
More (1 of 2) >
Load List From Step Sweep >
Confirm Load From Step Sweep.
The points you defined in the step sweep are automatically
loaded into the list.
4. Press the More (2 of 2) softkey. This softkey menu along with the numeric keypad, arrow keys,
and front panel knob can be used to edit the sweep points in the
list. For more information about editing sweep points, refer to
Chapter 2, “Using Functions,” of the ESG Family Signal
Generators User’s Guide.
qsg.book Page 7 Friday, September 22, 2000 3:13 PM