Filter
Top Products
English–1
1 619 929 565 • (03.05) T
1 SPECIFIC SAFETY RULES
FOR DRILL HAMMERS
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions
contained therein are strictly fol-
lowed.
In addition, the general safety
notes in the enclosed booklet must
be observed.
Before using for the first time, ask
for a practical demonstration.
To prevent damage to hearing, wear
hearing protection.
Wear safety glasses.
For long hair, wear hair protection.
Work only with close-fitting clothes.
Dust produced while working can be detrimental to
health, inflammable or explosive. Suitable protection
measures are required.
Examples: Some dusts are considered to be carcino-
genic. Use suitable dust/chip extraction and wear a
dust protection mask.
Light metal dust can burn or explode. Always keep the
work place clean since material mixtures are especially
dangerous.
If the cable is damaged or cut through while working,
do not touch the cable but immediately pull the power
plug. Never use the machine with a damaged cable.
Connect machines that are used in the open via a re-
sidual current device (RCD) with an actuating current
of 30 mA maximum. Do not operate the machine in
rain or moisture.
Always direct the cable to the rear away from the ma-
chine.
Use suitable detectors to find hidden utility lines
or call the local utility company for assistance.
Contact with electric lines can lead to fire or electrical
shock. Damaging a gas line can result in an explosion.
Penetrating a water pipe will cause property damage
or an electrical shock.
Operate the machine only with the auxiliary handle
11
.
Secure the work piece.
A work piece held with
clamping devices or in a vise is more secure than when
held by hand.
Place the machine on the nut/screw only when
switched off.
Be careful when screwing in long screws; danger of
sliding off.
When working, always hold the machine firmly with
both hands and provide for a secure stance.
Always switch the machine off and wait until it has
come to a standstill before placing it down.
Never allow children to use the machine.
Bosch is able to ensure perfect functioning of the ma-
chine only if the original accessories intended for it are
used.
Overload Clutch
If the drill bit becomes jammed or caught, the drive to
the drill spindle is interrupted. Because of the forces
that occur as a result,
always hold the machine se-
curely with both hands and take a firm stance.