Filter
Top Products
tNSTALUNGFEEDHANDLES(FIG.H)
1_Threadeachfeedhandle(1)intothethreaded
holes(2)onthehubassembly(3)andTighten_
Fig.H
4. Unlockthetablesupportlock(4-Fig.D)andswing
thetableawayfromthebottomofthechuck.
5. Usinga rubbermalletora hammeranda blockof
wood,tapthechuckontothespindlefirmly(Fig.K).
Fig.K
tNSTALUNGTHECHUCK(FIG.J,J ANDK)
1. Cleanoutthetaperedholeinthechuck(1)witha
cleanclothanda non-alcoholbasedcleaner.Wipe
cleanalloil resideandanydirtorgrimethoroughly.
2. Cleantaperedsurfacesonthespindle(2)in the
samemannerasabove.
NOTE:Makesuretherearenoforeignparticles
stickingtothesurfaces.Theslightestpieceofdirtor
oilresideonanyof thesesurfaceswillpreventthe
chuckfromseatingproperly.Thiswil!causethedrill
chuckandbittowobble.Iftaperedholeisextremely
dirty,usea non-alcohoJbasedcleanerona cleanrag
toclean.
MOUNTINGDRILLPRESSTOWORKSURFACE
(FIG.L}
1. If mountingthedrillpresstoaworkbench,a solid
woodbenchispreferredoveraplywoodboard,to
reducenoiseandvibration.
2. Holesshouldbepre-drilledthroughthesupporting
surface.
3. Thehardwareto mountthisdrillpressisNOT
suppliedwiththetoolThehardwareasshowninthe
illustrationshouldbeused:
@
Fig. t _l,ii,,_ Fig. L
2
Fig. J
1. Dril! press base
2. Bolt
3. Fiat washer
4. Rubber washer
5. Worksurface
6. Flatwasher
7. Lockwasher
8. Hex nut
9. Jam nut
3. Open the jaws of the chuck (1) by rotating the chuck
sleeve clockwise. To prevent damage, make sure the
jaws are completely receded into the chuck, j 2
3
4
._:=__ 1 [I
E_
I I
2 _
i i
6 9
5 7 8
12