Filter
Top Products
[AWARNING]
For your own safety, turn the switch OFF and remove
the plug from the power source outlet before maintaining
or lubricating your dril! press_
Frequently blow out, using an air compressor or dust
vacuum, any dust that accumulates inside the motor.
Wear protective safety goggles.
[AWARNRNGj
To avoid shock or fire hazard, Jfthe power cord is worn
or cut in any way, have it replaced immediately.
LUBRICATmON
All of the drill press bal! bearings are packed with grease
at the factory. They require no further lubrication.
Periodically lubrbate the gear and rack, table elevation
mechanism of the spindle the rack (teeth) of the quill
CHANGING THE LASER BATTERIES (FIG. DD)
Unplug your drill press.
[,AWARN NGI
Failure to unplug your too! could result in accidental
starting causing possible serious personal injury.
1. Open the battery cover (1).
2. Remove and replace the two batteries.
3. Replace the battery cover.
NOTE: Replace the batteries with batteries that have
a rating of 1.5 volts (Number 4 series and AAA size
or equivalent). When replacing the batteries, the
battery guide should be thoroughly cleaned. Use a soft
paintbrush or similar device, to remove al! sawdust and
debris.
Fig. DD
1
2O