Filter
Top Products
[AWARNINGI
To prevent persona! injury, always disconnect the plug
from the power source when making any adjustments.
SPINDLE / QUILL (FIG. O)
Rotate the feed handles counterclockwise to lower
spindle to its lowest position. Hold the chuck and move
itfront to back. If there is excessive play, proceed with
the following adjustments:
1. Loosen the lock nut (1) located on the right side of
the drill press.
2. Turn the screw (2) clockwise to eliminate the play,
but without obstructing the upward movement of the
spindle. (A little play in the spindle is normaL)
3. Tighten the lock nut (1).
Fig.0
QUILL RETURN SPRING (FIG. P)
The quill return spring may need adjustment if the quil!
return speed is too rapid or too slow.
1. Lower the table for additiona! clearance.
2. Place a screwdriver in the lower front notch (1) of the
spring cap (2). Hold it in place while loosening and
removing only the outer jam nut (3).
3. With the screwdriver still engaged in the notch,
loosen the inner nut (4) just until the notch (5)
disengages from the boss (6) on the drit! press head.
NOTE: DO NOT REMOVE THIS INNER NUT,
because the spring will forcibly unwind.
4. Carefully turn the spring cap (2) counterclockwise
with the screwdriver, engaging the next notch.
5. Lower the quil! to the lowest position by rotating the
feed handle in a counterclockwise direction while
holding the spring cap (2) in position.
6. If the quill moves up and down as you desire, tighten
the inner nut (4) sung against the spring cap and
secure the outer nut (3) against the inner nut with the
adjustable wrench.
NOTE: DO NOT OVERTIGNTEN and restrict quil!
movement.
5
Fig. P 6
1
2
IAWARNmNGI
To avoid injury from an accidenta! start, ALWAYS make
sure the switch is in the "OFF" position, the switch key
is removed, and the plug is not connected to the power
source outlet before making belt adjustments.
BELT TENS!ON (FIG. Q)
1. To unlock the belt tension, turn the belt tension lock
knob (1) on the right side of the drill press head
counterclockwise.
2. Pull the motor (2) toward the front of the drill press to
loosen the belt tension.
3. Position the belt on the correct pulley steps for the
desired speed.
4. Push the motor away from the dril! press head until
the belt is properly tensioned.
NOTE: Belt tension is correct if the belt deflects
approximately 1/2 inch when pressed at its center.
5. Tighten the belt tension lock knob (1) to secure the
motor in position.
Fig.Q
J 2
THE LASER TRAC®
Your tool is equipped with our latest innovation, the
Laser Trac®, a battery powered device using Class
II laser beams. The laser beams wil! enable you to
preview the drill bit path on the workpiece to be drilled
before you begin your operation.
14