Filter
Top Products
BASmC DRILL PRESS OPERATmONS
NOTE: This machine incorporates view windows on the
pulley cover used to observe the location of the belL
[AWARN NG!
To avoid possible injury, keep guard closed and in place
while tool is in operation.
SPEEDS AND BELT PLACEMENT (FIG. S)
J,AWARNING j
ALWAYS lock the switch "OFF" when the drill press is
not in use by removing the safety switch key keep it in a
safe place. In the event of a power failure, blown fuse,
or tripped circuit breaker, turn the switch "OFF" and
remove the key, preventing an accidental startup when
power comes on.
Fig. T
This drill press has 5 speeds, as listed below:
620 RPM 1100 RPM 1720RPM
2340 RPM 3100 RPM
See inside of the pulley guard for specific placement of
the belts on the pulleys to change speeds.
Fig. S
620RPM 1100RPM 1720RPM
3100RPM2340RPM
ON/OFF SWITCH (FIG. T)
The ON / OFF switch has a removable, safety switch
key. With the key removed from the switch, unauthorized
and hazardous use by children and others are minimized
as the switch can not be turned on without the key
1. To turn the drit! press "ON", insert key (2) into the slot
of the switch (1). Move the switch upward to the "ON"
position.
2. To turn the driJl press "OFF", move the switch
downward.
3. To lock the switch in the OFF position, grasp the
sides of the safety switch key, and pult it out.
4. With the switch key removed, the switch wi!! not turn
the power tool on.
5. If the switch key is removed while the drill press
is running, it can be turned "OFF" but cannot be
restarted without inserting the switch key.
INSTALLING DRILL BIT IN CHUCK (FIG. U)
1. With the switch "OFF" and the switch key removed,
open the chuck jaws (1) using the chuck key (2). Turn
the chuck key counterclockwise to open the chuck
jaws (1).
2. insert the drill bit (3) into the chuck far enough to
obtain maximum gripping by the jaws, but not far
enough to touch the spirat grooves (flutes) of the drilJ
bit when the jaws are tightened.
3. Make sure that the drii! is centered in the chuck.
4. Turn the chuck key clockwise to tighten the jaws.
[_WARNING ]
To avoid injury or accident by the chuck key ejecting
forcibly from the chuck when the power is turned "ON",
use only the self-ejecting chuck key supplied with this
drill press. ALWAYS recheck and remove the chuck key
before turning the power "ON".
16