Filter
Top Products
TO ASSEMBLE THE LEG STAND
See Figure 7.
Assembly is best done in the area where the saw will
be used. If you are unsure about the description of any
part, refer to the drawing. If any parts are missing, delay
assembling until you have obtained the missing part(s).
[] Take the following from a small hardware pack:
16 carriage bolts (1/4 - 20 x 1/2 in.)
16 hex nuts (1/4 - 20)
[] Take 4 legs and 8 braces from loose parts.
[] Place an upper brace inside two of the legs, with the
legs wide end up. (Upper braces have two large holes
in each end.) Make sure the dimples on the leg align
with the small holes on the brace.
[]
Align the large holes on the brace and the legs. Insert
the bolts. Add hex nuts and hand tighten. Repeat for
the other upper brace. These are the front and back
sets.
[] For the side sets, install an upper side brace on two
legs. Add hardware and finger tighten.
[] Use the same steps to install the lower braces. Tighten
all hex nuts securely with the socket wrench.
[] Install a foot to the bottom of each leg.
[] Move the leg set to desired location.
CARRIAGE
UPPER BOLT_._
BRACE
MOUNTING THE TABLE SAW BASE ON THE LEG
STAND
See Figure 8.
[] Take the following from a small hardware pack:
4 carriage bolts (1/4-20 x 1-3/8 in.)
4 hex nuts (1/4-20)
NOTE: This hardware was in the pack with hardware
for assembling the leg stand and leveling feet.
[] Place the table saw base on the leg stand. Align the
holes in the table with the holes in the end braces.
[] Place a bolt in each hole. Secure with a hex nut. Hand
tighten.
[] Repeat for three remaining holes. Tighten all hardware
securely with the socket wrench.
CARRIAGE
BO_
HEX
NUT
LOWERSiDE
BRACE
HEX
NUT
FOOT
LEG
LOWER
BRACE
CARRIAGE
BO_
Fig. 7
HEX
NUT
Fig. 8
17