Filter
Top Products
TO INSTALL THE HANDLE
See Figure 9.
[] Hold the nylon nut securely and turn the screw
counter- clockwise to remove the nut completely.
NOTE: Do not remove the screw from the handle.
[] Place the nylon nut into the recessed hole on the back
of the height/bevel adjusting handwheel and hold in
place.
[] Slide the handle, screw, and washer into the hole on
the height/bevel adjusting handwheel.
[] Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
HANDLE
SCREW
NYLON HEIGHT/ BEVEL
NUT ADJUSTINGHANDWHEEL
Fig. 9
TO INSTALL THE LOCKING LEVER
See Figure 10.
[] Slide the locking lever over the exposed end of the rip
fence making certain the handle is inserted as far as
possible.
[] Align the holes in the rip fence and the holes in the
lever. Secure using the screws.
RiP
FENCE
LOCKING
LEVER
SCREWS
Fig. 10
TO REMOVE/REPLACE THE THROAT PLATE
See Figure 11.
[] Lower the blade by turning the height/bevel adjusting
handwheel counterclockwise.
[] To remove the throat plate, place your index finger in
the hole and liftthe front end pulling the throat plate
out toward the front of the saw.
[] To reinstall the throat plate, slip the tab into the slot at
the back of the saw and push down to secure in place.
THROAT
PLATE
SPREADER/ RiViNG
KNIFE
®
®@
®
18