Filter
Top Products
10- ENG
A13567
Unpacking
1. Remove unit from carton and
discard all packaging. NOTE:
Save all parts bags.
The wheels and
handle do not
provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
Installing Handle
Do not use the
engine gas tank
as a support for lifting the air
compressor.
1. Insert the handle into pockets
under the tank saddle. Put one
set screw through hole in one
side of tank saddle and tighten
down on handle.
Handle
Set Screw
Tank Saddle
It will be necessary
to brace or
support one side of the unit when
installing the wheels because the
compressor will have a tendency
to tip.
1. Attach the rubber feet to the
bottom of the foot extension
bracket as shown. Attach foot
extension bracket to the air tank
bracket as shown.
2. Attach wheels with shoulder
bolts and nuts as shown. Place
the bolts in the top hole of
the wheel bracket on unit.
3. Tighten securely. NOTE: The
unit will sit level if the wheels are
properly installed.
Rubber Foot
Extension Bracket
Cap Screw
Lock Washer
Hex Nut
Cap Screw
Shoulder Bolt
Wheel
Hex Nut
Handle
Set Screw
Tank Saddle
Assemble Wheels and Rubber
Feet for Portability
Excessive tank
vibration can
weaken the air tank and cause
rupture or explosion. Rubber feet
must be installed.