Filter
Top Products
9 - ENG
A13567
ACCESSORIES
This unit is capable of powering the following Accessories. The accessories are
available through the current Power and Hand Tool Catalog or full-line Sears
stores.
GLOSSARY
Become familiar with these terms
before operating the unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per
minute; a unit of measure of air
delivery.
PSIG: Pounds per square inch
gauge; a unit of measure of pressure.
Code Certifi cation: Products that
bear one or more of the following
marks: UL, CUL, ETL, CETL, have
been evaluated by OSHA certifi ed
independent safety laboratories and
meet the applicable Underwriters
Laboratories Standards for Safety.
Unloader Blow-Off Pressure: All
models are continuous running units
controlled by tank pressure. When the
maximum tank pressure is obtained,
the unloader valve will blow-off. This
will cause the compressor to exhaust
the air to the atmosphere and not the
tank. This decreases the load on the
engine and allows it to run at a near
no-load condition.
Unloader Reset Pressure: When
the tank pressure drops to a
predetermined point, the unloader
valve closes. The tank pressure will
now increase until it reaches the
unloader blow-off pressure.
Accessories
• In Line Filter
• Tire Air Chuck
• Quick Connector Sets (various
sizes)
• Air Pressure Regulators
• Oil Fog Lubricators
• Air Hose:1/4", 3/8" or 1/2" I.D. in
various lengths
Refer to the selection chart located
on the unit to select the tools this unit
is capable of powering.
ASSEMBLY
Contents of Carton
1 - Air Compressor
1 - Thread Sealant Tape
1 - Screw .250-20 .625 Set Square
1 - Shut-off Valve 1/4" NPT
1 - Engine Manual
1 - Owner's Manual
4 - Vibration Mount
8 - Lock Washer
4 - Flat Washer
8 - Hex Nut .313-18 UNC
4 - Cap Screw
4 - Hex Nut .250-20 UNC
2 - Hex Nut .375-16 UNC
2 - Rubber Feet
1 - Foot Bracket
2 - Shoulder Bolt
2 - Lock Washer
1 - Handle
1 - Grip Handle
2 - Wheel
Tools Required for Assembly
1 - a 9/16" socket or open-end
wrench for attaching the wheels
1 - a 7/16" open-end wrench for
attaching the foot extension
bracket and rubber feet
1 - a 1/4" open-end wrench for
attaching the shut-off valve and
air outlet adapter.