Filter
Top Products
Assemble Shut-Off Valve
1. Apply pipe sealant to the tapered
pipe threads on the shut-off
valve and tighten into the
manifold.
11 - ENG
A13567
Permanent Installation
Bolting legs to a
stiff surface can
cause tank rupture resulting in
serious injury or damage. Do not
permanently mount compressor
to any surface without using the
vibration mount kit.
This compressor may be permanently
mounted in a location such as a truck
bed, it desired. A vibration mount kit
is included for this purpose.
1. In order to maintain adequate
ventilation for compressor
cooling and to avoid contact with
pick-up truck bed, always mount
the unit at least 8" from any
vertical wall. Using the holes in
the air tank legs as a guide, mark
and drill four 5/16" diameter
holes in the mounting surface.
2. Insert the vibration mounts in
the mounting holes. Place a
fl at washer under the mounting
surface and secure each mount
with a lock washer and nut.
3. Set the unit on the exposed
threaded ends of the mount
to the air tank legs with a lock
washer and nut.
Lubrication and Oil Engine
Drain tank to
release air
pressure before removing the oil fill
cap or oil drain plug.
1. The engine was fi lled WITH
oil at the manufacturer. Check
engine oil level before operating
unit. If necessary, fi ll engine
to the appropriate level with
recommended oil, see engine
manual supplied by engine
manufacturer for correct
procedure.
2. Add fuel to engine. See engine
manual supplied by engine
manufacturer for correct
procedure.
Gasoline vapor is
highly fl ammable.
Refuel outdoors preferably, or only
in well-ventilated areas. Do not
refuel or check gasoline level while
the engine is running. Do not store,
spill, or use gasoline near an open
fl ame, a source of sparks (such
as welding), or near operating
electrical equipment.
Air Compressor
The air compressor pump was fi lled
WITH oil at the manufacturer. Check
air compressor pump oil level before
operating unit. If necessary, fi ll pump
to the appropriate level with approved
compressor oil, see the Maintenance
section of this manual for details.
shut-off valve
manifold