Filter
Top Products
8
B
Fig. 3A
A
Fig. 4A
A
B
Fig. 3
C
D
A
B
Fig. 4
With the cuttinghead in the up position, attach the dust
shroud (A) Fig. 4A to the port (B) with three screws using
the supplied wrench.
NOTE: Installation is easier if you place a screw on the
wrench and then place it in the hole.
ATTACHING DUST BAG
1. Attach dust spout (A) Fig. 3 into port (B).
2. Depress spring clips (C) Fig. 3 of dust bag (D) and clip
dust bag (D) over rib of dust spout (A).
MOVING CUTTINGHEAD TO THE UP POSITION
Push down on the handle (B) Fig. 3A, pull out cuttinghead
lockpin and move the cuttinghead (B) to the up position
(Fig. 4).
DISCONNECT THE MACHINE FROM
THE POWER SOURCE.
ATTACHING DUST SHROUD
1. Carefully remove the machine from the carton. Retain all packing materials until you have inspected and
satisfactorily operated the machine.
2. Place the machine on a firm, level surface with proper support of the workpiece.
3. The 36-412 is shipped with the cuttinghead beveled right to 45° and locked in the down position, and the table
rotated 45° left. To release the head and move it to the operating position, see “MOVING CUTTINGHEAD TO THE
UP POSITION” and “MOVING THE TABLE TO THE 0° CUT-OFF POSITION” sections in this manual.
DO NOT OPERATE THIS MACHINE UNTIL YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION
MANUAL.
ASSEMBLY
ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE - 30 minutes
* 2mm hex wrench (supplied)
*
1
/2
” arbor wrench (supplied)