Filter
Top Products
1) Connect the Sub-D plug on the Video Web Server with the COM/NO ports of the
Sensor.
2) Set the “Mail setting” item in the system configure.
NOTE 1 : You can get all the data from the ISP ( Internet Service Provider) company or by
mailing to the server supplier (POP3/SMTP server).
NOTE 2 : You should set the mail list when the alarm is triggered.
NOTE 3 : When the alarm is triggered, you can find “ ” message showed on the screen.
The AP will start recording automatically and you can get the email with the
snapshot image in your mailbox.
APPENDIX #2 – SENDING E-MAIL
-36-
Video Web Server
N.O. Sensor
Pin 5
Pin 4,7, 8 or 9
GND
ALARM INPUT
A normally open contact/sensor can be connected where
Pin 5 is Ground and Pin 4, 7, 8 and 9 is the Alarm Input
digimerge.eng
digimerge.eng
dliu@digimerge.com