Filter
Top Products
Remote DataTrak Operation
313526J 25
Remote DataTrak Operation
Startup
1. Turn the air motor slider valve (BF) off before turn-
ing the remote DataTrak power on.
2. Turn on the remote DataTrak system using the
rocker switch on the ram power supply.
3. The Splash screen (F
IG
. 18) will flash on while the
progress bar fills from left to right. It will then go
directly to Run mode (F
IG
. 19).
4. Follow the Start and Adjust Pump procedure in the
pump manual.
Run Mode
See F
IG
. 16 and F
IG
. 19.
The Run Mode screen displays the resettable job total
counter (JT), maintenance counter (MC), cycle/flow rate
(CF), and the remaining volume in the drum (DV) in both
numeric and icon versions.
Key Functions When in Run Mode
1. To enter Prime Mode, press and release .
2. To enter Setup Mode (page 26), press and hold
for 3 seconds.
3. To enter Diagnostic Mode (page 29), press and
release . The system will enter Diagnostic Mode
only if there are active warnings/alarms.
4. To reset the job total counter, press and hold
from Run Mode for 3 seconds.
NOTICE
To prevent damage to soft key buttons, do not press
the buttons with sharp objects such as pens, plastic
cards, or fingernails.
NOTICE
If the motor air valve is not turned off, the air supply to
the motor will automatically turn on via activation of
the air solenoid (X) when the display changes from
the Splash screen to Run mode.
F
IG
. 17
F
IG
. 18: Splash Screen
ti10433a
ti10433a
All items are displayed using the defined volume
units (VU).
F
IG
. 19: Run Mode Screen
CF
MC
JT
DV