Filter
Top Products
Remote DataTrak Operation
313526J 31
Disconnected Solenoid Diagnostic Code
Screen
See F
IG
. 28. If the system detects a disconnected air
motor solenoid and the E4 Diagnostic Code is enabled,
the Disconnected Solenoid screen becomes active.
1. Press and release to exit the Disconnected
Solenoid screen.
2. Correct the condition causing the diagnostic code;
see T
ABLE
4, page 33.
3. This diagnostic code will automatically clear when
the system detects that the solenoid is connected.
Drum Low/Empty Diagnostic Code Screen
See F
IG
. 29 and F
IG
. 30. If the drum low/empty sensor
trips, the Drum Low or Drum Empty screen becomes
active, depending on which sensor setting is chosen,
see page 28.
1. Press and release to exit the Drum Low/Empty
screen. This will set the diagnostic code as a stand-
ing diagnostic code. A standing diagnostic code has
not been cleared, simply acknowledged.
2. Replace the low or empty drum with a full drum.
When the sensor no longer detects a low or empty
drum the diagnostic code will clear automatically.
F
IG
. 28: Disconnected Solenoid Diagnostic Code
Screen
F
IG
. 29: Drum Empty Diagnostic Code Screen
F
IG
. 30. Drum Low Diagnostic Code Screen