Filter
Top Products
Remote DataTrak Operation
313526J 29
Diagnostic Mode
Diagnostics
Remote DataTrak can diagnose several problems with
the supply system. When the monitor detects a problem,
the LED (B, F
IG
. 16) will flash and a diagnostic code will
appear on the display. See Table 4, page 33.
If the accessory light tower kit is installed a light will illu-
minate or flash on the tower. See T
ABLE
4.
To acknowledge the diagnosis and return to the normal
operating screen, press once. To clear a diagnostic
code, see the section specific to the code.
See F
IG
. 16. Press and release to access the Diag-
nostic screens. The system will enter Diagnostic Mode
only if active warnings/alarms are present.
Runaway Diagnostic Code Screen
See F
IG
. 25. If pump runaway occurs, the Runaway
screen becomes active, stopping the pump.
1. Correct the condition causing the diagnostic code.
See T
ABLE
4, page 33.
2. Press and release to acknowledge the diagnos-
tic code and return to the previous screen.
3. To clear the Runaway diagnostic code:
a. Press and release to enter Diagnostic Mode
from Run Mode (F
IG
. 19).
b. Press and release to scroll to the Runaway
Diagnostic screen, or return to the previous Run
screen if no other Diagnostic screens are active.
c. Press and hold for 3 seconds while on the
runaway Diagnostic screen to clear the diag-
nostic code and scroll to the next available
Diagnostic screen, or return to the previous Run
screen if no other Diagnostic screens are active.
Diagnostic screens will become the active screen
as soon as the diagnostic code condition is
detected. See T
ABLE
4.
F
IG
. 25: Runaway Diagnostic Code Screen
RS
NOTICE
Clearing this diagnostic code will immediately cause
the air solenoid to activate, applying air to the motor.
To disable runaway monitoring, go to setup mode
and set runaway value to 0 (zero) or toggle (RT)
off. See F
IG
. 22.