Filter
Top Products
G0636X 17" Ultimate Bandsaw
-15-
Although not required, we recommend that you
mount your new machine to the floor. Because
this is an optional step and floor materials may
vary, floor mounting hardware is not included.
However, you must level your machine with a
precision level.
You may also mount your machine to a mobile
base (see Figure
10) that has wheel locking or
wheel retracting capabilities that keep the mobile
base from rolling when the bandsaw is in use.
We recommend using the Grizzly Model G7315
mobile base.
Bolting to Concrete Floors
Lag shield anchors with lag bolts (Figure 9) and
anchor studs
are two popular methods for anchor-
ing an object to a concrete floor. We suggest
you research the many options and methods for
mounting your machine and choose the best that
fits your specific application.
Mounting to Shop
Floor
NOTICE
Anchor studs are stronger and more per-
manent alternatives to lag shield anchors;
however, they will stick out of the floor,
which may cause a tripping hazard if you
decide to move your machine
.
Figure 9. Typical fasteners for mounting to
concrete floors.
Figure 10. Bandsaw mounted on G7315 mobile
base.
Guide Post
Handwheel
To install the guide post handwheel:
1. Insert the guide post handwheel onto the
shaft, and secure it with the cap screw on
the flat side of the shaft, as shown in
Figure
11.
Figure 11. Guide post handwheel installed.