Filter
Top Products
-26-
G0636X 17" Ultimate Bandsaw
Aligning Fence
Figure 33. Cap screws securing rail to table.
5. Adjust the fence face parallel with the edge of
the miter slot, as shown in
Figure 34.
NOTICE
Adjusting the fence parallel to the miter slot
does not guarantee straight cuts. The miter
slot may need to be adjusted parallel to
the side of the blade. Refer to the "Aligning
Table" instructions on Page
25.
6. Tighten the two cap screws that secure the
rail to the table, being careful not to move the
fence.
Figure 34. Example of fence square with miter
slot.
Cap Screws
To ensure cutting accuracy when the fence is first
installed, the fence should be aligned with the
miter slot.
To align the fence parallel with the miter slot:
1. DISCONNECT BANDSAW FROM POWER!
2. Make sure the miter slot is aligned with the
bandsaw blade (see
Page 25).
3. If the fence is mounted on the left-hand side
of the blade, remove it and remount it next to
the miter slot.
4. Loosen the two cap screws that secure the
rail to the table (
Figure 33).