Filter
Top Products
-18-
G0449/G0450 37" Drum Sander
Installing Handwheel
Components and Hardware Needed: Qty
Handwheel ........................................................
1
To mount the handwheel:
1. Place the handwheel over the shaft shown
in Figure
11 and tighten the setscrew in the
handwheel hub.
Figure 11. Handwheel location.
Dust Collection
This drum sander requires a minimum of 1600
CFM at the sander. We recommend using a dust
collection system that produces a minimum of
2000 CFM. A fine layer of dust will be present on
your stock as it comes out of the sander. This is
normal.
Components and Hardware Needed: Qty
Dust Hoses 4" (not included) ........ Length Varies
Hose Clamps (not included) .......................
Varies
Dust Collection System (not included) ...............
1
To connect the dust ports to a dust collector:
1. Attach 4" dust collection hoses to the dust
ports shown in
Figure 12 and secure them
with hose clamps.
Figure 12. Dust port locations.