Filter
Top Products
-26-
G0449/G0450 37" Drum Sander
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person
-
al injury.
Moving parts such as chains should be lubricated
periodically with a light machine oil. Motor bear
-
ings need no lubrication.
Use only adequate lubrication. Too much lubri
-
cant will attract dirt and sawdust and will clog the
chain mechanism.
Pillow Bearing: Must be lubricated every 20
hours of operation. Use a high-quality, lithium-
based grease. A grease fitting (Figure 23) is
located on the top of each pillow bearing.
Lubrication
Cleaning the Model G0449/G0450 is relatively
easy. From time to time vacuum wood dust off of
the internal components, especially the motor.
Cleaning
SECTION 6: MAINTENANCE
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check
:
• Loose mounting bolts.
• Worn switch.
• Worn or damaged cords or plugs.
• Damaged V-belts.
• Any other unsafe condition.
Schedule
DO NOT attempt to investigate or adjust
any features of the machine while it is run
-
ning. Wait until the machine is turned
OFF,
unplugged, and all working parts have come
to a rest before you do anything!
Gearbox: The oil in the gearbox should be
changed every 500 hours with new SAE 80W
gear oil.
1. Remove the motor cover, loosen the four hex
bolts that secure the gear box to the motor
bracket, and remove the V-belt.
Figure 23. Location to lubricate pillow bearing.