Filter
Top Products
-14-
G0460/G0461 12" Sliding Table Saw
5. Remove the magnetic switch cover.
6. Replace the original magnetic switch assem
-
bly with the assembly included in the 440V
conversion ki
t. Set the dial on the new over-
load relay to 11A (Figure 9).
4. Rewire the motor per the diagram on the
inside of the motor junction box, using the
additional wiring nuts included with the 440V
conversion kit.
Note: A wiring diagram is provided in the back
of this manual for your reference
; it is current
at the time of printing, but the machine may
change. The diagram on the inside of the
motor junction box will always be current with
the motor.
3. Remove the motor junction box cover (see
Figure
8).
Figure 9. Magnetic switch.
Overload
Relay Dial
Overload
Relay
Magnetic
Contactor
7. Reinstall the switch cover.
Figure 8. Motor location.
Motor
Junction Box