Filter
Top Products
G0460/G0461 12" Sliding Table Saw
-47-
Figure 80. Fence adjustment test piece.
3. Use the crosscut fence to cut
1
⁄2" off of each
side of the test piece, then cut side 1 again
(make 5 cuts total).
4. Measure the test piece diagonally from cor-
ner-to-corner as shown in
Figure 80.
— If both measurements are not within
1
⁄16",
then the crosscut fence needs to be adjust
-
ed. Proceed to
Step 5.
— If both measurements are within
1
⁄16" then
you are finished with this procedure.
5. Loosen the hex nut shown in Figure 81 and
rotate the hex bolt to square the crosscut
fence.
6. Tighten the hex nut and repeat Steps 3-6.
Figure 81. Crosscut fence adjustment cam.
Hex Nut
Squaring the crosscut fence to the blade ensures
that cuts made with the crosscut fence will be
square. This procedure consists of cutting a piece
of scrap plywood five times, then adjusting the
fence as necessary.
To square the crosscut fence with the blade:
1. Make sure the blade is parallel with the slid-
ing table.
2. Prepare the scrap test piece by numbering all
four sides as shown in
Figure 80.
Squaring Crosscut
Fence to Blade