Grizzly G0554Z Lathe User Manual


  Open as PDF
of 104
 


     


       


    

Factory adjustments that should be verified:
 Page 33
 Page 58
 Page 58
Recommended
Adjustments
NOTICE
Successfully complete all of the spindle
break-in steps to avoid rapid deterioration
of the spindle bearings and components.
Spindle Break-In
To break-in the spindle bearings:
1.  Test Run 
Page 16
2. 
3.      
Step 6
Page 17
4. 
Setting Spindle SpeedPage 38

5. 

      

6. 
        




7. Steps 2–6

NOTICE
After the first 16 hours of use, the V-belts
will stretch and seat into the pulley grooves.
The V-belts must be properly re-tensioned
after this period to avoid severely reducing
their useful life (refer to the Tensioning/
Replacing V-Belts section on Page 53 for
detailed instructions.
8. OFF


9.         


      

Spindle Bearing Preload 
Page 62

Spindle Break-In   

 previous next