Grizzly G0554Z Lathe User Manual


  Open as PDF
of 104
 


NOTICE
ALWAYS make sure the spindle is turned
OFF and is at a complete stop before
changing any gear configuration to prevent
damage to the lathe gearing and voiding the
warranty.
Setting Feed Rate Controls


To set the feed controls:
1. OFF
  

2.        
     
Figure 57
      

Open
Locked
Figure 57.

3. 
Figure 55Page 41 


4. 

    Figures 58–59

A4C
Note:You may need to rock the spindle,
leadscrew, or feed rod back-and-forth by
hand to get the gears to properly engage.
A
B
A
Position
B
Position
Figure 58.A
C
D
O
E
F
1
2
3
4
5
6
7
8
Numeric Feed
Rate Knob
C–F Feed
Rate Knob
Figure 59.4C
5.        
     

 previous next