Filter
Top Products
Faceplate
ACCESSORIES Page 48
Use a minimum of three independent
clamping devices to hold a non-concentric
workpiece onto the faceplate. Failure to do
so could cause the workpiece to be ejected
from the lathe, which could result in serious
personal injury or property damage.
Loading Workpiece
1.
2.
Figure 34.
3.
Figure 34
Note: Take into account the rotation and
cutting forces that will be applied to the
workpiece when clamping it to the faceplate.
Always use a low spindle speed when
machining non-concentric workpieces or
for off-center turning to avoid ejecting the
workpiece from the mounting device at
a high rate of speed. Failure to heed this
warning could lead to serious personal
injury, death or property damage.