Filter
Top Products
Tailstock Alignment
To align the tailstock offset to the spindle cen-
ter line:
1.
2.
3.
Step 6
4.
Figure 39
Figure 39.
Note: As long as this dead center remains in
the chuck, the point of the center will remain
true to the spindle center line. The point will
have to be refinished whenever the center is
removed and then returned to the chuck.
5.
6.
Step 3
Figure 40
Figure 40.
7.
8.
Note: If necessary in the following step,
refer to Cutting Shallow Tapers with the
Tailstock on Page 32 for adjusting the
tailstock offset.