Grizzly G0554Z Lathe User Manual


  Open as PDF
of 104
 


Offsetting Tailstock
       
        
       
       
   
   


Note: To return the tailstock to the center position,
perform the Tailstock Alignment procedure on
the next page.
Tools Needed Qty
 
To set up the tailstock to cut a shallow taper:
1. 

       
Figure 38
5.       

       

6.        

       

7. 
      
        

Note: Do not overly force the center into
the workpiece with the handwheel—this will
make removing the center very difficult and
could damage it.
8.        




Figure 38.




 previous next