Filter
Top Products
To mount a workpiece onto the spindle dead
center:
1.
2.
3.
Note: After applying the oil and wiping the
surfaces, do not touch the mating surfaces
with your hands or other objects, which could
deposit moisture or debris.
4.
5.
Figure 36
6.
Note: Hold onto the sleeve and center as
you tap them loose to avoid dropping them
and damaging the tip of the center or the
bedways.
NOTICE
To avoid premature wear of the dead center
or damage to the workpiece, always use
lower spindle speeds and keep the tip of the
dead center mounted in the tail stock well
lubricated with an anti-sieze compound.
Figure 37.
Using a Center in the Tailstock
Figure 37
To mount a workpiece onto the tailstock dead
center:
1.
2.
3.
Note: After applying the oil and wiping the
surfaces, do not touch the mating surfaces
with your hands or other objects, which could
deposit moisture or debris.
4.