Grizzly G0554Z Lathe User Manual


  Open as PDF
of 104
 


Always use a low spindle speed when
machining non-concentric workpieces or
for off-center turning to avoid ejecting the
workpiece from the mounting device at
a high rate of speed. Failure to heed this
warning could lead to serious personal
injury, death or property damage.
4-Jaw Chuck
      
      


     

Mounting Workpiece
Tools Needed Qty
 

 
To mount a workpiece onto the 4-jaw chuck:
1. 
2. 

3. 


4.      



5.   


Figure 32
1
2
3
4
Workpiece
Center Point
Figure 32.
6.         





     
     
Figure 33
Figure 33.

 previous next