Filter
Top Products
G0560 Meat-Cutting Bandsaw -13-
Components and Hardware Needed: Qty
Rubber Feet ......................................................4
Feet Bracket ......................................................4
Hex Bolt M6-1 x 20 ............................................4
Stand Side..........................................................2
Stand Side Brace ..............................................2
Stand Top ..........................................................1
Top Panel “S” Brace ..........................................1
Motor Mounting Bracket ....................................1
Carriage Bolt M8-1.25 x 16 ..............................16
Hex Nut M8-1.25 ..............................................20
Flat Washer 8mm ............................................20
Tools Needed:
10mm Wrench or Socket....................................2
To assemble the stand:
All stand pieces except the rubber feet should be
assembled with the M8-1.25 x 16 carriage bolts,
M8 hex nuts, and 8mm washers.
1. Attach the stand sides to the stand top as
shown in Figure 7. Make sure the side of the
stand with the switch cutout is on the same
side as the V-belt cutout on the top piece.
This will ensure that the switch is in front of
the bandsaw. Do not completely tighten the
carriage bolt nuts at this time.
Stand
2. Place the (4) feet brackets on the stand cor-
ners where the rubber feet will be installed.
3. Insert the (4) M6-1 x 20 hex bolts into the
rubber feet and attach the feet to the stand
corners as shown in Figure 8.
Figure 8. Rubber foot and foot brackets.
Figure 7. Stand sides attached to stand top.
Figure 9. Stand braces attached to stand sides.
4. Attach the side braces to the stand sides as
shown in Figure 9.
Switch Cutout
V-belt Cutout
Rubber Foot
Foot Bracket
Side Braces