Filter
Top Products
G0560 Meat-Cutting Bandsaw -17-
Stand Covers
Figure 18. Catch tab in place on stand cover.
Components and Hardware Needed: Qty
Tap Screws #6 x
3
⁄8" ........................................12
Catch Tabs ......................................................12
Stand Covers......................................................2
Tools Needed:
Phillips Head Screwdriver ..................................1
The stand covers need catch tabs installed in all
the predrilled holes as shown in Figure 17 & 18.
Figure 17. Stand covers with catch tabs.
The stand covers fit inside the stand openings
and attach by turning the catch tabs over the
edges of the stand.
Figure 19. Table guard installed.
The blade and table guards prevent contami-
nants from falling into the saw.
Components and Hardware Needed: Qty
Blade Guard ......................................................1
Table Guard ......................................................1
Knob Screw M6-1 x 12 ......................................6
To install the guards:
1. Place the table guard around the bandsaw
throat on the top edge as shown in Figure
19.
Blade & Table
Guards
2. Secure the table guard in place with a knob
screw on each side of the guard.
3. Place the blade guard around the side of the
bandsaw covering the blade as shown in
Figure 20
.