Filter
Top Products
-16- G0560 Meat-Cutting Bandsaw
Before you put on the V-belt, make sure that the
motor pulley and the upper pulley are reasonably
aligned. To do this, loosen the setscrew on the
motor pulley, adjust the motor pulley so it is in-line
with the upper pulley, then tighten the setscrew.
To put on the V-belt:
1. Loosen the (4) motor mount bolts.
2. Raise the motor up and fit the V-belt in the
pulley grooves, then let the motor down.
3. Place slight pressure on the motor to tension
the belt and tighten the (4) motor mount
bolts. Make sure that the motor does not
twist and double check the pulley alignment.
Adjust the positioning as needed.
4. Check for approximately
1
⁄4" deflection. If the
belt is not tensioned correctly, repeat steps
1 and 3 until it is correct.
V-Belt
Figure 15. Bandsaw unit on stand.
Figure 16. Installing special hex bolt.
Components and Hardware Needed: Qty
Bandsaw Base Unit............................................1
Special Hex Bolt M10-1.5 x 16 ..........................3
2. Line up the holes in the corner of the stand
with the holes on the bottom of the bandsaw
unit.
3. Fasten the stand to the bandsaw unit with
the (3) M10-1.5 x 16 special hex bolt as
shown in Figure 16.
Bandsaw Unit
The Model G0529
weighs 127 lbs.
Personal injury could
occur if the machine is
moved without addition-
al assistance. Seek help
when moving or lifting
the machine.
To install the bandsaw unit onto the stand:
1. Place the bandsaw base unit onto the stand
as shown in Figure 15. Get help so you do
not strain yourself.