Filter
Top Products
G0560 Meat-Cutting Bandsaw -19-
Figure 23. Securing rails in the sliding table.
Figure 22. Installing force plate.
4. Secure the rails to the end of the table using
the knob screws as shown in Figure 23.
2. Slide the bandsaw blade through the slot in
the sliding table and place the table on the
rollers. Note—Be careful when placing the
table on the saw. The other end of the rails
are not secured to the table.
3. Secure the force plate under the open edge
of the table with the M6-1 x 12 knob screws
as shown in Figure 22.
5. Tighten the rails in place so that they slide in
the roller groove.
Note—This table adjustment may take some
trial and error. It is best to position the inside
rail so the blade is centered in the slot, then
squeeze the outer rail into the roller groove
and tighten the knob screws. It is important
that the rails are secure in the rollers and the
blade does not make contact with the table.
6. Check to make sure the rails are in the roller
grooves and that the table slides smoothly
(Figure 24).
Figure 24. Checking table position.