Filter
Top Products
-20- G0560 Meat-Cutting Bandsaw
Figure 25. Fence supports to table.
Figure 26. Fences assembled.
Figure 27. Fences installed on supports.
The fences allow you to support the meat as you
slide it through the blade while also controlling the
thickness of cut.
Components and Hardware Needed: Qty
Fence Support Brackets ....................................2
Hex Bolts M6-1 x 20 ..........................................4
Fence Shafts ......................................................2
Fences................................................................2
Knob Screws M6-1 x 12 ....................................4
Flat Washer ........................................................4
Tools Needed:
Wrench 10/12mm ..............................................1
To install the fence:
1. Use the M6-1 x 20 hex bolts to attach the
fence brackets to the table as shown in
Figure 25.
Fence
2. Insert the fence shafts into the fences and
secure them in place with the knob screws
(Figure 26).
3. Slide the long fence into the bracket on the
left and the short fence into the bracket in
front (Figure 27).
4. Secure the fence assemblies in the brackets
with knob screws.