Filter
Top Products
-10-
G0592 Metal Cutting Bandsaw
Additional Safety Instructions for Metal
Cutting Bandsaws
8. FIRE HAZARD. Use EXTREME CAUTION
if cutting mag
nesium. Using the wrong cut-
ting fluid will lead to chip fire and possible
explosion.
9. CUTTING FLUID SAFETY. Always follow
manufacturer’s cutting fluid safety instruc-
tions. Pay particular attention to contact,
contamination, inhalation, storage and dis
-
posal warnings. Spilled cutting fluid is a
slipping hazard and a toxicity hazard.
10. ATTENTION TO WORK AREA. Never
leave a machine running and unattended.
Pay attention to the actions of others in the
area to avoid unintended accidents.
11. MAINTENANCE/SERVICE. All inspec
-
tions, adjustments, and maintenance are
to be done with the machine
OFF and the
power disconnected to the machine. Wait
for all moving parts to come to a complete
stop.
12. HEARING PROTECTION & HAZARDS.
Noise generated by blade and workpiece
vibration, material handling, and power
transmission can cause permanent hear-
ing loss over time and interfere with
com-
munication and audible signals. Al
ways
wear hearing protection.
13. HOT SURFACES. Due to friction, the
workpiece, chips, and some machine com
-
ponents can be hot enough to burn you.
1. BLADE CONDITION. Do not operate with
dull, cracked or badly worn blade.
Inspect
blades for cracks and missing teeth before
each use.
2. HAND PLACEMENT. Never position fin
-
gers or thumbs in line with the cut.
Hands
could be crushed in vise or by falling
machine components or cut by the blade.
3. ENTANGLEMENT HAZARDS.
Do not
operate this bandsaw without blade guard
in place. Otherwise, loose clothing, jew
elry,
long hair and wo
rk gloves can be drawn
into working parts.
4. B
LADE REPLACEMENT. When replacing
blades, make sure teeth face toward the
workpiece. Wear gloves to protect hands
and safety glasses to protect eyes.
5. WORKPIECE HANDLING. Always sup
-
port the workpiece
with table, vise, or other
support fixture. Flag long pieces to avoid a
tripping hazard. Never hold the workpiece
with your hands during a cut.
6. LOSS OF STABILITY. Unsupported
workpieces may jeopardize machine sta
-
bility and cause the machine to tip and fall,
which could cause serious injury.
7. POWER INTERRUPTION. Unplug machin
e
after power interruption. Machines without
magnetic switches can start up after power
is restored.
No list of safety guidelines can be complete. Every shop environment is different. Like all
machines there is danger associated with the Model G0592. Accidents are frequently caused by
lack of familiarity or failure to pay attention. Use this machine with respect and caution to lessen
the possibility of operator injury. If normal safety precautions are overlooked or ignored, serious
personal injury may occur.