Filter
Top Products
-26-
G0592 Metal Cutting Bandsaw
Figure 26. Coolant system reservoir and cover.
4. Adjust the valves on the coolant hoses to
control the flow of coolant
(see Figure 27).
Make sure that the pressure is not so high
that coolant spills on the floor and creates a
slipping hazard.
Figure 27. Coolant control valve.
Coolant Control Valve
5. Turn the coolant pump switch ON before
making your cut.
NOTICE
Keep the tray chip screen clear so coolant
can recycle to the pump reservoir. NEVER
operate the pump with the reservoir below
the low mark or you will over-heat the pump
and void your warranty
!
Figure 29. Spray gun.
6. Monitor the coolant level frequently to keep
the system working properly. DO NOT let
coolant level fall out of view on the sight glass
(see Figure 28).
To use the spray gun:
1. Close the coolant control valves.
2. Turn the coolant pump switch ON. You are
ready to spray.
Figure 28. Coolant level sight glass.