Grizzly G0592 Saw User Manual


 
G0592 Metal Cutting Bandsaw
-19-
The adjustments listed below have been per-
formed at the factory. However, because of the
many variables involved with shipping, we recom
-
mend that you at least verify the following adjust
-
ments to ensure accurate cutting results.
Step-by-step instructions on verifying these adjust-
ments can be found in SECTION 7: SERVICE
ADJUSTMENTS.
Factory adjustments that should be verified:
1. Blade Tracking (Page 35).
2. Blade Guide Bearings (Page 36).
Recommended
Adjustments
Starting the machine:
1. Read the entire instruction manual.
2. Make sure all tools and foreign objects have
been removed from the m
achine.
3. Put on safety glasses and secure loose
clothing o
r long hair.
4. Connect the bandsaw to power.
5. Raise the bandsaw and close the feed con-
trol knob to keep the saw in place
.
Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses during
assembly and operation.
Test Run
6. Start the bandsaw while keeping your finger
near the EMERGENCY S
TOP/OFF button
(Figure 14) at all times during the test run.
The bandsaw should run smoothly with little
or no
vibration.
Note: If the EMERGENCY STOP/OFF button
is pressed, it needs to be twisted until it pops
out or the bandsaw will not start
.
If you suspect any problems, immediately
stop the bandsaw and correct before con
-
tinuing.
—If you need any help with your bandsaw
call our Tech Support at (570) 546-9663.
Figure 14. Control panel.
E-STOP/OFF Button
Feed control knob
ON