Filter
Top Products
G0592 Metal Cutting Bandsaw
-7-
Control Panel
A. Coolant Pump Switch: Turns the coolant
pump ON.
B. EMERGENCY
STOP/OFF Button: Interrupts
power to the system and turns the motor
OFF. Twist the button until it pops out to re-
energize the system. Also works as a stan
-
dard OFF button.
Note: The bandsaw has an automatic shut-
off (limit switch) that turns the machine OFF
at the completion of the cutting
arc.
C. START Button
: Turns the motor ON and
activates moving parts.
D. Power Light
: When lit, indicates that system
is energized and machine is ready to oper
-
ate.
E.
Feed Rate Dial: Fine tunes the feed rate by
controlling the hydraulic valve. Range is from
1 being slowest to 9 being fastest.
F. Feed Control Knob
: Turning the knob to the
left lowers the bow at the feed rate you have
set. Turning the knob to the right locks the
bow in position.
Figure 2. G0592 control panel.
A
B
C
D
E
F