-24-
G0592 Metal Cutting Bandsaw
The table shown in Figure 22 is a sampling of
speed rates for various materials. Use these as a
guideline.
The speed at which the saw blade will cut through
a workpiece is controlled by blade type
, feed rate,
and feed pressure. The feed rate is controlled by
two knobs on the control panel.
Note
: If a lubricant is used on the cut, the feed
rate can be increased by approximately 15%
.
To set the feed rate:
1. Raise the bow to the highest position.
2. Set the Feed Rate Dial
to the desired feed
rate. Range is from 1 being slowest, to 9
being fastest.
3. Turning the Feed Control Knob to the left to
lower the bow at the feed rate you have set.
Turning the knob to the right locks the bow in
position.
• If you get a tightly curled, warm shavings,
brown to black in color, you are using too
much downward pressure.
• Blue looking chips are from extreme heat
with a high band saw speed.
• Thin powder-like chips are from insuffi-
cient feed pressure. This will dull your blade
rapidly.
• The best cut and feed rate will give you
evenly shaped spiraled curls with very little
color change, if any at all.
Feed Rate
Figure 23. Feed rate dial (shown with guard
removed).
Feed Rate Dial
Material Alloy ASTM Number
Ft/Min Mtrs/Min
Copper 173,932
314 96
Alloys 330,365
284 87
623,624
264 81
230,260,272
244 74
280,264,632,655
244 74
101,102,110,122,172
234 71
1751,182,220,510
234 71
625, 706, 715, 934
234 71
630 229 70
811 214 65
Carbon
1117 339 103
Steels
1137 289 88
1141,1144
279 85
1141 High Stress
279 85
1030 329 100
1008,1015,1020,1025
319 97
1035 309 94
1018,1021,1022
299 91
1026,1513
299 91
A36 (SHAPES),1040
269 82
1042,1541
249 76
1044,1045
219 67
1060 199 61
1095 184 56
Nickle 8615, 8620, 8622
239 73
Chrome 4340, E4340, 8630
219 67
Molybdenum
8640 199 61
Alloys E9310
174 53
Tool Steels A-6
199 61
A-2
179 55
A-10
159 49
D-2
90 27
H-11,H-12,H-13
189 58
Stainless 420 189 58
Steels
430 149 46
410,502
140 43
414 115 35
431 95 29
440C 80 24
304, 324
120 36
304L 115 35
347 110 33
316, 316L
100 30
416 189 58
Blade Speed
Figure 22. Material speed table.