G0592 Metal Cutting Bandsaw
-17-
Shipping Bracket Workstop
Figure 8. Shipping bracket.
A bracket has been installed to keep the saw in
alignment during shipping. Before using your saw
you will need to remove it. Store it for safe keep
-
ing, in the event you move your saw to a different
location.
To remove the shipping bracket:
1. Remove the upper hex bolt with a 12mm
wrench.
2. Remove the two lower cap screws with a
5mm hex wrench.
Figure 10. Workstop.
The workstop on the Model G0592 has three main
parts including the workstop rod, arm and work-
stop. The workstop is easy to adjust and can be
set up on either side of the vise.
To install the workstop:
1. Slide the workstop rod in the hole in the base
of the vise and tighten the set screw.
2. Slide the arm onto the workstop rod and
tighten the set screw.
Figure 9. Workstop assembly.
Set screw
Set screw
3. Insert the workstop into the arm and secure
with the knob.
Arm
Workstop
Knob
Workstop Rod