Filter
Top Products
G0592 Metal Cutting Bandsaw
-21-
4. Pull the vise all the way to the opposite side
of the base and lock it in position (see
Figure
16).
5. Install the chip trays and splash guards to the
new side.
Figure 16. Vise to the right.
Figure 17. Vise jaw positioning.
Latch
The vise jaw width can be quickly adjusted when
changing from one sized material to another.
To rapidly change the vise jaw gap:
1. Use the handwheel to relieve any pressure
on the vise jaw.
2. Flip the latch up to disengage it from the
leadscrew (see
Figure 17).
3. Pull or push the jaw in the desired direction.
4. Engage the lever with the leadscrew and fin-
ish tightening the jaw with the handwheel.
Note: Figure 18 shows the proper methods
for holding different workpiece shapes.
Always turn the saw OFF and allow the blade
to come to a complete stop before using the
vice! Failure to follow this caution may lead
to injury.
Figure 18. Workholding options by material
shape.