Filter
Top Products
-22-
G0605X/G0606X Extreme Series 12" Table Saw
3. Place the extension table assembly upright
with the feet on the ground
, align the slots in
the extension table bracket with the rear rail
mounting holes, then fasten the table to the
rail with two M8-1.25 x 16 flange bolts and
hex nuts shown in
Figure 20.
Figure 21. Fence tube mounted to front fence
rail.
Figure 20. Outfeed table fastened to rear rail.
Flange Bolts
4. Secure the lower shelf brackets to the sup-
port legs and cabinet with four M6-1 x 12 hex
bolts, four flat washers and two hex nuts.
5. Install the lower shelf on the brackets.
6. Place the 91
3
/8" fence tube over the 91
3
/8"
front rail and secure with nine M8-1.25 x 12
flange bolts as shown in
Figure 21.
Flange Bolt
Saw Blade
Review this section, even if your saw blade came
pre-installed.
To install the blade:
1. DISCONNECT THE SAW FROM POWER!
2. Remove the table insert, blade guard, and
splitter–if previously
installed.
3. Use the arbor wrenches to loosen and remove
the arbor nut, flange, and blade.
Note: The arbor nut has right hand threads;
turn it counterclockwise to loosen.
4. Slide the blade over the arbor with the teeth
facing the front of the saw, as shown in
Figure 22.
The saw blade is extremely sharp. Use extra
care when handling the blade or working
near it. Serious injury is possible.
5. Re-install the arbor flange and the arbor nut,
and tighten them against the b
lade with the
wrench included with the saw. DO NOT over
-
tighten.
Figure 22. Correct blade direction.
Front Of Saw
Teeth Direction
& Blade Rotation
Bracket